35
14 .1. Corner brackets
The system has a corner bracket on each side.
Repeat the procedure for both corners.
14.2. Riser brackets
The system has a small bracket on five of the
risers (all except the outer risers). Repeat the
procedure for the five risers.
Make sure that the bracket hangs
in the inner slot on the riser.
1. Hang the corner bracket in the inner slot
of the riser, and fasten it with two screws
(M6x12, Torx 30).
2. Adjust the foot of the corner bracket until the
bracket is level.
3. Tighten the upper nut to lock the foot's
position.
1. Hang the bracket on the riser.
2. Fasten the bracket with one screw
(M6x12, Torx 30).
To Next Page
Loading...