43
17.2. Fasten the upper trim
1. Enter three screws (M4x12, Torx 20) into the trim
support as shown, without tightening.
2. Hang the trim onto the screws.
3. Tighten the three screws, and add two more
(M4x12, Torx 20) - one of them with a spacer and
two washers.
Don't tighten the
screws so much
that it becomes
difficult to hang the
trim on them.
Add a spacer and
two washers to
the center screw.
To Next Page
Loading...