Firmware Information
• Firmware Version – The firmware version number installed on the router.
• Firmware MD5 Checksum – A value used for file validation.
• Locale – Defined localization support.
• Language Version – Language version.
• Language MD5 Checksum – A value used for language file validation.
Port Status
• Port ID – Defined name and number of the port.
• Interface – Name of the interface used for the connection.
• Status – Status of connection
• Speed – Connection speed.
IPv4 and IPv6
Internet Protocol version 4 (IPv4) and Internet Protocol version 6 (IPv6) are numerical IP addresses necessary
for Internet-enabled devices to communicate. Without IP addresses, computers would not be able to
communicate and send data to each other. It's essential to the infrastructure of the web.
This section diplays the following:
• IP Address – IP address assigned to the interface.
• Default Gateway – Default gateway for the interface.
• DNS – IP address of the DNS server. A DNS server is a computer server that contains a database of
public IP addresses and their associated hostnames.
• Dynamic DNS – Dynamic domain name system (DNS) is a method of automatically updating a name
server in the DNS, often in real time, with the active DDNS configuration of its configured hostnames,
addresses or other information. This displays the IP address of the DDNS for the interface and if it is
Disabled or Enabled.
• Disconnect – Click to disconnect the connection.
• Renew – Click to renew the IP address.
• Connect or Disconnect buttons are applicable when the WAN connection type is PPTP, L2TP, and
PPPoE.
• WAN gets connected only if you reconnect or change the WAN configuration after disconnecting the
existing WAN connection.
Note
RV260x Administration Guide
12
Status and Statistics
System Summary
To Next Page
Loading...
Need help?
General
