Cisco RV260 series User Manual

To open this page, select Launch Setup Wizard in the navigation pane and follow the on-screen instructions
to proceed. Refer to your ISP for the information required to setup your Internet connection.
Launch Setup Wizard
Link to the Initial Router Setup.Initial Router Setup
Link to the VPN Status Wizard.VPN Setup Wizard
Initial Configuration
Link to the User Accounts page where you can change the administrator
password and set up a guest account.
Change Administrator
Password
Link to the WAN Settings page where you can modify the WAN parameters.Configure WAN Settings
Link to the Mobile Network page where you can modify the USB configurations.Configure USB Settings
Link to the VLAN Membership page where you can configure the VLAN.Configure LAN Settings
Quick Access
Link to the File Management page where you can update the device firmware.Upgrade Router
Firmware
Link to the Firewall >Basic Settings page where you can enable the basic
features of the device.
Configure Remote
Management Access
Link to the Config Management page where you can manage the router’s
configuration.
Backup Device
Configuration
Device Status
Link to the System Summary page that displays the IPv4 and IPv6 configuration,
and firewall status on the device.
System Summary
Link to the VPN Status page that displays the status of the VPNs managed by
this device.
VPN Status
Link to the Port Traffic page which displays the device’s port status and port
traffic.
Port Statistics
Link to the TCP/IP Services page which displays the device’s port listen status
and the established connection status.
Traffic Statistics
Link to the View Logs page which displays the logs on the device.View System Log
User Interface
The user interface is designed to make it easy to set up and manage the device.
The header toolbar icons are described in the table below.
RV260x Administration Guide
7
Getting Started
User Interface

Cisco RV260 series Specifications

General

Brand	Cisco
Model	RV260 series
Category	Network Router
Language	English