CHAPTER 4
System Configuration
This section describes the device's system configuration and contains the following topics:
• Initial Router Setup, on page 31
• System, on page 33
• Time, on page 33
• Log, on page 34
• Email, on page 36
• User Accounts, on page 36
• User Groups, on page 38
• IP Address Groups, on page 40
• SNMP, on page 40
• Discovery-Bonjour, on page 41
• LLDP, on page 41
• Automatic Updates, on page 42
• Schedules, on page 43
• Service Management, on page 43
• PnP (Plug and Play), on page 43
Initial Router Setup
You can check the connection and configure the basic router settings on the Initial Setup Wizard page. From
the Run Setup Wizard page, you can follow the instructions that guide you through the process for configuring
the device.
Step 1 Click System Configuration > Initial Router Setup to access the Router Setup Wizard.
Step 2 Click Next to go to Check Connection page. If your router has detected a connection, the connection details are displayed
on this page.
Step 3 Click Next.
Step 4 The Configure Router – Select Connection Type pop-up appears. Select your internet connection type.
Step 5 If you select Dynamic IP or DHCP (Recommended), click Next.
Step 6 If you select Static IP Address, click Next and configure these settings.
RV260x Administration Guide
31
To Next Page
Loading...
Need help?
General
