Enter a name for the community.Set Community
Trap Configuration
Using Trap configurations, you can set the source address of every SNMP trap packet sent by the router to a single address
regardless of the outgoing interface.
Step 2 To configure the SNMP trap, enter the following information.
Enter the name of the trap community.Trap Community
Enter the IP address.Trap Receiver IP Address
Enter the port number.Trap Receiver Port
Step 3 Click Apply.
Discovery-Bonjour
Bonjour is a service discovery protocol that locates network devices such as computers and servers on your
LAN. When this feature is enabled, the device periodically multicasts Bonjour service records to the LAN to
advertise its existence.
For discovery of Cisco Small Business products, Cisco provides a utility that works through a simple toolbar
on the web browser called FindIt. The FindIT Discovery Utility discovers Cisco devices in the network and
display basic information, such as serial numbers and IP addresses. For more information and to download
the FindIT Discovery Utility, visit www.cisco.com/go/findit.
Note
To enable Discovery-Bonjour, follow these steps:
Step 1 Select System Configuration > Discovery-Bonjour.
Step 2 Check Enable, to enable Discovery-Bonjour globally. (It is enabled by default).
Step 3 Check Apply.
LLDP
The Link Layer Discovery Protocol (LLDP) is a vendor-neutral protocol used by network devices for advertising
their identity, capabilities, and neighbors on an IEEE 802 local area network. The LLDP information is sent
by the device’s interface at a fixed interval, in the form of an Ethernet frame. Each frame contains one LLDP
Data Unit (LLDPDU). Each LLDPDU is a sequence of type-length-value (TLV) structure.
To configure LLDP, follow these steps:
RV260x Administration Guide
41
System Configuration
Discovery-Bonjour
To Next Page
Loading...
Need help?
General
