C-18
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-UNASSIGNCFG_OK: "Current application on slot slot-num was
successfully un-assigned."
Explanation
This message is displayed when an application is successfully unassigned from a line
card slot.
In this message, slot-num indicates the slot number.
Recommended Action None.
Error Message %LOCAL7-6-REPLACE_CFG_START:"Starting application replace of
application file
Explanation
This message is displayed while replacing the existing application with a new
application for the corresponding line card slot.
Recommended Action None.
Error Message %LOCAL7-6-LOGGER_INIT_SUCCESS: "Logger task Initialized successfully"
Explanation
This message is displayed when logger task initialization is successful.
Recommended Action None.
Error Message %LOCAL7-6-EXIT_BY_REQUEST : "Logger exit request received. Exiting
logger ..."
Explanation
This message is displayed when the logger task exits after receiving an exit request
message from an event.
Recommended Action None.
Error Message %LOCAL7-6-LINE_ATTACK_FILES_CLEAR: "Cleared line-attack log files"
Explanation
This message is displayed when the line-attack log file is cleared. Line-attack messages
are stored in a line-attack log file.
Recommended Action None.
Error Message %LOCAL7-6-ACTIVE_CONNECTION_OPEN: "Formatter active connection opened
Explanation
This message is displayed to provide the details of the RDR formatter IP address, port
number, and the category of the connection that is in active state.
Recommended Action None.