Cisco SCE 8000

C-25
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-DBG_INIT_OPENED_NEW_FILES: "DBG - failed opening files for
read & write. New files were opened, old files deleted."
Explanation
This message is displayed when the DBG fails to open the files to perform read and
write operations. The new files are opened and the old files deleted. This occurs when an attempt is
made to initialize the debug log files and these files are not found.
Recommended Action None.
Error Message %LOCAL7-6-TESTING_INFO_LEVEL: "syslog test message for info severity
level"
Explanation
This message is displayed to indicate the information severity level.
Recommended Action None.
Error Message %LOCAL7-6-SESSION_BAD_LOGIN: "Bad password attempted on a CLI session
from <%s>."
Explanation
This message is displayed when a wrong password is given by a user while logging into
the CLI session.
Recommended Action None.
Error Message %LOCAL7-6-LINK_UP_TRAP: "Link up trap generated for Mng interface %d."
Explanation
This trap is generated by the SNMP when the managing interface is up.
Recommended Action None.
Error Message %LOCAL7-6-SNMP_TRAP: "<%s>"
Explanation
All types of SNMP traps generate this message with the details of the traps.
Recommended Action None.
Error Message %LOCAL7-6-AUTHENTICATION_FAILURE_TRAP: "Authentication failure."
Explanation
This message is generated when authentication failure of an SNMP trap occurs.
Recommended Action None.
Error Message %LOCAL7-6-OPERATIONAL_STATUS_WARNING_TRAP: "<%s>"
Explanation
This SNMP trap is generated to indicate that the Cisco SCE platform is operational until
one of the following states occur:
– Link on one of the line ports is down
– Management port link is down