Cisco SCE 8000

C-26
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
– Temperature raised above threshold
– Voltage not in required range
– Fans problem
– Power supply problem
– Insufficient space on the disk
Note If the condition that causes the Cisco SCE platform to be in the Warning state is resolved, it
means that when the link is up, the Cisco SCE platform will revert back to the operational state.
Recommended Action None.
Error Message %LOCAL7-6-OPERATIONAL_STATUS_FAILURE_TRAP: "<%s>"
Explanation
This SNMP trap is generated to indicate that the Cisco SCE platform will be in the
failure state after reboot due to one of the following conditions:
– Power on test failure
– Three abnormal reboots in less than 20 minutes
– Platform configured to enter the failure mode consequent to failure-induced reboot, which is
configurable using a CLI command
Note Depending on the cause of the failure, the management interface and the Cisco SCE platform
configuration may or may not be active or available.
Recommended Action None.
Error Message %LOCAL7-6-SYSTEM_RESET_BYUSER_TRAP: "<%s>"
Explanation
This SNMP trap is generated when the system is reset by a user.
Recommended Action None.
Error Message %LOCAL7-6-SYSTEM_RESET_BYFATAL_TRAP: "<%s>"
Explanation
This SNMP trap is generated when the system is reset by a fatal trap.
Recommended Action None.
Error Message %LOCAL7-6-SNMP_COLDSTART_TRAP: "<%s>"
Explanation
This SNMP trap is generated when the SNMP agent restarts.
Recommended Action None.