Cisco SCE 8000

C-34
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-CHANGE_MODE_AUTO: "Management Failover mode has been changed
to automatic mode."
Explanation
This message is generated when the management failover mode is changed to automatic
mode.
Recommended Action None.
Error Message %LOCAL7-6-CHANGE_MODE_MANUAL: "Management Failover mode has been
changed to manual mode."
Explanation
This message is generated when the management failover mode is changed to manual
mode.
Recommended Action None.
Error Message %LOCAL7-6-SIMBA_USR_HW_MONITOR_OK: "<%s>
Explanation
This message is displayed when any of the hardware component statuses change from
the error state or warning state to the normal state.
Recommended Action None.
Error Message %LOCAL7-6-SIMBA_USR_ALL_HW_MONITORS_OK: "All hardware monitors report
status OK"
Explanation
This message is generated when the status of all the hardware components that are
monitored by the sanity check change from the error state or warning state to the normal state.
Recommended Action None.
Error Message %LOCAL7-6-PROBLEM_IS_OK: "<%s>"
Explanation
The system operational status indicates the current status of the system. This message
is displayed to indicate that the operational status mentioned in the description is not severe.
Recommended Action None.
Error Message %LOCAL7-6-EXECUTING_CONFIG_FILES: "Beginning execution of
configuration files."
Explanation
This message is displayed when the execution of the startup configuration, application
configuration, and party database configuration files begins.
Recommended Action None.