Cisco SCE 8000

C-35
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-CONFIG_FILES_OK: "Configuration files executed with no
errors."
Explanation
This message is generated when all the startup configuration files are executed without
any errors during the system boot process.
Recommended Action None.
Error Message %LOCAL7-6-SSH_ERROR: "Failed starting SSH server, error is %s."
Explanation
This message is generated when Cisco SCE fails to start the SSH server during the
system boot process that is mentioned in the error description.
Recommended Action None.
Error Message %LOCAL7-6-OPERATIONAL_STATUS_CHANGED: "<%s>"
Explanation
This message is generated when the system operational status is changed as mentioned
in the description.
Recommended Action None.
Error Message %LOCAL7-6-LOSS_OF_SYNC: "Lost synchronization with peer '<%s>' -
removing its subscribers"
Explanation
This message is triggered by the Service Control Management Protocol (SCMP) engine
when it detects the loss of synchronization with the peer identified by the corresponding peer name.
Cisco SCE removes all the events sent to the peer connection and all the subscribers owned by that
peer connection.
Recommended Action None.
Error Message %LOCAL7-6-PEER_CONNECTED: "Connection established with peer '<%s>'"
Explanation
This message is displayed when connection with the corresponding peer is established.
Recommended Action None.
Error Message %LOCAL7-6-PEER_CLOSE: "Closing connection with peer '<%s>' - <%s>"
Explanation
This message is generated when any of the following conditions occur:
– When a user requests that a debug be closed.
– When a user requests that the connection be closed.
– When the SCMP engine is disabled.
– When Cisco SCE becomes the standby engine in the SCMP engine.
– When a keepalive session timeout occurs.
– When a peer-indicated connection is down.