Cisco SG220-26 Administration Guide

Administration: Discovery
Configuring CDP
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 101
8
STEP 4 Click Apply. The CDP port settings are modified, and the Running Configuration is
updated.
Viewing CDP Local Information
The CDP Local Information page displays information that is advertised by the
CDP protocol about the local device.
To view the CDP local information:
STEP 1 Click Administration > Discovery CDP > CDP Local Information.
STEP 2 Select a local port, and the following fields are displayed:
• CDP State—Displays whether CDP is enabled or disabled on the port.
• Device ID TLV
-
Device ID Type —Type of the device ID advertised in the device ID TLV.
-
Device ID —Device ID advertised in the device ID TLV.
• Address TLV
-
Address(s) —IP addresses (advertised in the device address TLV).
• Port TLV
-
Port ID —Identifier of port advertised in the port TLV.
• Capabilities TLV
-
Capabilities —Capabilities advertised in the port TLV.
• Version TLV
-
Version —Information about the software release on which the device is
running.
• Platform TLV
-
Platform —Identifier of platform advertised in the platform TLV.
• Native VLAN TLV
-
Native VLAN —The native VLAN identifier advertised in the native VLAN
TLV.

Cisco SG220-26 Specifications

General

Model	SG220-26
Category	Switch
Ports	24 x 10/100/1000 + 2 x Gigabit SFP
Switching Capacity	52 Gbps
Forwarding Rate	38.69 Mpps
Layer	Layer 2
PoE	No
Mounting	Rack-mountable
MAC Address Table Size	8K entries
Power Supply	Internal
Management	Web-based
Jumbo Frame Support	9216 bytes
Operating Temperature	0°C to 40°C (32° to 104°F)
Storage Temperature	-20°C to 70°C (-4° to 158°F)
Humidity	10% to 90%, non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p