Cisco SG220-26 Administration Guide

Administration: Discovery
Configuring LLDP
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 96
8
To view LLDP overloading information:
STEP 1 Click Administration > Discovery LLDP > LLDP Overloading.
The following fields are displayed:
• Interface—Port identifier.
• Total By tes In-Use—Total number of bytes of LLDP information in each
packet.
• Available Bytes Left —Total number of available bytes left for additional
LLDP information in each packet.
• Status—If TLVs are transmitted, or if they are overloaded.
STEP 2 Select a port and click Details.
The following fields are displayed:
• LLDP Mandatory TLVs
-
Size (Bytes) —Total mandatory TLV byte size.
-
Status —If the mandatory TLV group is transmitting, or if the TLV group
was overloaded.
• LLDP MED Capabilities
-
Size (Bytes) —Total LLDP MED capabilities packets byte size.
-
Status —Whether the LLDP MED capabilities packets were sent or they
were overloaded.
• LLDP MED Location
-
Size (Bytes) —Total LLDP MED location packets byte size.
-
Status —Whether the LLDP MED location packets were sent or they were
overloaded.
• LLDP MED Network Policy
-
Size (Bytes) —Total LLDP MED network policies packets byte size.
-
Status —If the LLDP MED network policies packets were sent, or if they
were overloaded.
• LLDP MED Expanded Power via MDI

Cisco SG220-26 Specifications

General

Model	SG220-26
Category	Switch
Ports	24 x 10/100/1000 + 2 x Gigabit SFP
Switching Capacity	52 Gbps
Forwarding Rate	38.69 Mpps
Layer	Layer 2
PoE	No
Mounting	Rack-mountable
MAC Address Table Size	8K entries
Power Supply	Internal
Management	Web-based
Jumbo Frame Support	9216 bytes
Operating Temperature	0°C to 40°C (32° to 104°F)
Storage Temperature	-20°C to 70°C (-4° to 158°F)
Humidity	10% to 90%, non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p