8-14
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
Chapter 8 Troubleshooting
Troubleshooting with the User Log
The SCE 2000# prompt appears.
How to Copy the User Log to an Internal Location
You can view the log file by copying it to disk. This command copies both log files to the local SCE
platform disk.
Step 1 From the SCE 2000# prompt, type logger get user-log file-nametarget-filenameand press Enter.
The SCE 2000# prompt appears.
How to View the User Log
Note This command is not recommended when the user log is large. Copy a large log to a file to view it (see
How to Copy the User Log to an External Source )
Step 1 From the SCE 2000# prompt, type more user-log and press Enter.
The user log appears, followed by the SCE 2000# prompt.
How to Clear the User Log
You can clear the contents of the user log at any time. The user log contains important information
regarding the functioning of the system. It is recommended that a copy be made before the log is cleared.
SUMMARY STEPS
1. From the SCE 2000# prompt, type clear logger device user-file-log and press Enter.
2. The system asks Are you sure?
3. Type y and press Enter.
DETAILED STEPS
Step 1 From the SCE 2000# prompt, type clear logger device user-file-log and press Enter.
Step 2 The system asks Are you sure?
Step 3 Type yand press Enter.
The SCE 2000# prompt appears.
To Next Page
Loading...
Need help?
General
