5-19
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Enter SNMP trap manager community string:
Step 12 Type the number of the trap manager SNMP version (1 or 2c) and press
Step 13 Enter
Note that there is no default for this parameter.
Enter trap manager SNMP version:
Step 14 The maximum number of trap managers is 20.
• To add more entries, type yand press
• Enter
Would you like to add another SNMP trap manager? [no]:y
• Enter up to 20 trap managers as described in through .
• When all entries have been added, press
• Enter
Would you like to add another SNMP trap manager? [no]:
Step 15 Configure the Authentication Failure trap status.
• To disable the Authentication Failure trap, press Enter.
• To enable the Authentication Failure trap, type yand press Enter.
Enable the ‘Authentication Failure’ trap [no]:
Step 16 Configure the SCE enterprise trap status.
• To disable the SCE enterprise traps, type npress Enter.
• To enable the SCE enterprise traps, type yand press Enter.
Enable the SCE enterprise traps []:
Step 17 Type the name of the system administrator and press Enter.
Note that there is no default for this parameter.
Enter system administrator contact name []:
EXAMPLE:
Following is a sample SNMP configuration, configuring one trap manager, one GET community, and
one SET community, and enabling the authentication failure trap, as well as all enterprise traps.
Would you like to enter the SNMP configuration menu? [no]: yEnable SNMP management? [no]:
yEnter SNMP GET community name[]: publicEnter Access list number allowing access with this
community string, use ‘0’ to allow all: 0Would you like to add another SNMP GET community?
[no]:
Enter SNMP SET community name[]: privateEnter Access list number allowing access with this
community string, use ‘0’ to allow all: 2Would you like to add another SNMP SET community?
[no]:
Would you like to configure SNMP trap managers? [no]: yEnter SNMP trap manager IP address:
10.1.1.253Enter SNMP trap manager community string: publicEnter trap manager SNMP version:
2cWould you like to add another SNMP trap manager? [no]:
Enable the ‘Authentication Failure’ trap [no]: yEnable SCE enterprise traps []: yEnter
system administrator contact name []: John Smith
Step 9: How to Configure the Topology-Dependent Parameters
The topology configuration menu is a series of guided questions relating to the deployment of the SCE
2000 in the network and its mode of operation. Values for the parameters are configured based on the
user answers.
To Next Page
Loading...
Need help?
General
