Port Management
Port Settings
SPS208G/SPS224G4/SPS2024 Service Provider Switches User Guide 40
3
• Admin Status — Enables or disables traffic forwarding through the port.
- Up — Indicates traffic forwarding is enabled through this port.
-
Down
— Indicates traffic forwarding is disabled through this port.
• Current Port Status — Displays the port connection status.
• Reactivate Suspended Port — Reactivates a link if the port has been
disabled through the locked port security option.
• Operational Status — Displays whether the port is currently operational or
non-operational.
• Admin Speed — The configured rate for the port. The port type determines
what speed setting options are available. The auto negotiation should be
disabled before setting the speed manually.
• Current Port Speed — Displays the current port speed.
• Admin Duplex — The port duplex mode. Full indicates that the interface
supports transmission between the device and the client in both directions
simultaneously. Half indicates that the interface supports transmission
between the device and the client in only one direction at a time.
• Current Duplex Mode — Displays the port current duplex mode.
• Auto Negotiation — Enables Auto Negotiation on the port. Auto Negotiation
is a protocol between two link partners that enables a port to advertise its
transmission rate, duplex mode and flow control abilities to its partner.
• Current Auto Negotiation — Displays the Auto Negotiation status on the
port.
• Admin Advertisement — Specifies the capabilities to be advertised by the
port. The possible field values are:
-
Max Capability
— Indicates that all port speeds and Duplex mode
settings can be accepted.
-
10 Half
— Indicates that the port is advertising a 10 mbps speed and
half Duplex mode setting.
-
10 Full
— Indicates that the port is advertising a 10 mbps speed and full
Duplex mode setting.
-
100 Half
— Indicates that the port is advertising a 100 mbps speed and
half Duplex mode setting.
To Next Page
Loading...
Need help?
General
