Cisco SPS208G User Manual

Port Management
Link Aggregation
SPS208G/SPS224G4/SPS2024 Service Provider Switches User Guide 43
3
The Link Aggregation Screen contains the following fields:
• LAG — Displays the LAG ID number.
• Description — Defines the user-defined LAG name.
• Admin Status — Enables or disables traffic forwarding through the selected
LAG. The possible field values are:
- Up — Indicates traffic forwarding is enabled through this LAG.
- Down — Indicates traffic forwarding is disabled through this LAG.
• Typ e — Displays the LAG type. Only ports matching this type can join this
LAG.
• Link Status — Indicates if the LAG is currently linked. The possible field
values are:
- Up — Indicates the LAG is currently linked, and is forwarding or
receiving traffic.
- Down — Indicates the LAG is not currently linked, and is not forwarding
or receiving traffic.
• Speed — Displays the configured aggregated rate for the LAG. The
possible field values are:
- 10M — Indicates the LAG is currently operating at 10 Mbps.
- 100M — Indicates the LAG is currently operating at 100 Mbps.
- 1000M — Indicates the LAG is currently operating at 1000 Mbps.
• Flow Control — Displays the flow control status of the LAG.
- Enable — Indicates that the Flow Control is enabled.
- Disable — Indicates that the Flow Control is disabled.
- Auto Negotiati on — Enables Auto Negotiation for the Flow Control. Auto
Negotiation is a protocol between two link partners that enables a port
to advertise its flow control state to its partner.
• LAG Mode — Displays the type of link aggregation. The possible field
values are:
- LACP — Link aggregation is set up using LACP.
- Static — LACP is disabled. Instead, link aggregation is set up.

Cisco SPS208G Specifications

General

Brand	Cisco
Model	SPS208G
Category	Switch
Language	English