Cisco UCS X9508 User Manual

To prevent loss of input power, ensure that the total maximum loads on the circuits supplying power to
the chassis are within the current ratings for the wiring and breakers.
• Use the following torque values when installing the chassis:
• M6 x 20 mm screws: 48 +/- 5 in-lb
Required Equipment
Before you begin the installation, ensure that you have the following items:
• Scissor jack or other lift device capable of bearing the weight of a fully loaded chassis, which is 400 lbs
(163.29 kg).
• Number 1 and number 2 Phillips-head screwdrivers with torque measuring capabilities
• Flat-head screwdriver
• Tape measure and level
• ESD wrist strap or other grounding device
• Antistatic mat or antistatic foam
Unpacking and Inspecting the Chassis
When handling chassis components, wear an ESD strap and handle modules by the carrier edges only.
Caution
Keep the shipping container in case the chassis requires shipping in the future.
Tip
The chassis is thoroughly inspected before shipment. If any damage occurred during transportation or any
items are missing, contact your customer service representative immediately.
Note
Step 1 Remove the chassis from its shipping container. Save all packaging material.
Step 2 Compare the shipment to the equipment list provided by your customer service representative and verify that you have
received the following items:
• Any printed documentation
• Accessory kit, which contains:
• M6 cage nut (4)
• M6 x 20mmL screw (16)
• Power Cable Management Arm (2), UCSX-9508-PCMA
Cisco UCS X9508 Server Chassis Installation Guide
26
Installation
Required Equipment

Cisco UCS X9508 Specifications

General

Brand	Cisco
Model	UCS X9508
Category	Server
Language	English