Before you begin
The rear mounting brackets (UCSX-9508-RACKBK) are a customer orderable option for systems that are
shipped pre-installed in a rack.
Step 1 At the rear of the chassis, use your hands to install each rear mounting bracket, which has a folded tab at the top and a
folded metal hook at the bottom.
a) Slide the hook the into the cutout in the chassis side wall.
b) Slide each rear mounting bracket until the tab seats into the emboss in the chassis top.
Figure 24: Attaching the Rear Mounting Brackets
Step 2 Holding the rear mounting brackets in place, use the #3 Phillips-head screwdriver to insert the 8 M6 x 20mm screws
through the rear mounting brackets, then tighten the screws to secure the rear of the chassis to the rear of the rack.
Cisco UCS X9508 Server Chassis Installation Guide
44
Installation
Installing Rear Mounting Brackets
To Next Page
Loading...
