Incoming Status (PW Status TLV):
Status code: 0x26 (Standby, AC Down) in Notification message
Outgoing Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
The following example shows sample output for the show l2vpn xconnect command:
RP/0/0/CPU0:router# show l2vpn xconnect
Legend: ST = State, UP = Up, DN = Down, AD = Admin Down, UR = Unresolved,
LU = Local Up, RU = Remote Up, CO = Connected
XConnect Segment 1 Segment 2
Group Name ST Description ST Description ST
---------------------------- --------------------------- -------------------------
siva_xc siva_p2p UP Gi0/4/0/1 UP 1.1.1.1 1 UP
Backup
2.2.2.2 2 UP
--------------------------------------------------------------------------------
The following sample output shows that the backup is in standby mode for the show l2vpn
xconnect detail command:
RP/0/0/CPU0:router# show l2vpn xconnect detail
Group siva_xc, XC siva_p2p, state is up; Interworking none
AC: GigabitEthernet0/4/0/1, state is up
Type Ethernet
MTU 1500; XC ID 0x5000001; interworking none; MSTi 0
Statistics:
packet totals: received 90, sent 90
byte totals: received 19056, sent 19056
PW: neighbor 1.1.1.1, PW ID 1, state is up ( established )
PW class not set, XC ID 0x5000001
Encapsulation MPLS, protocol LDP
PW type Ethernet, control word enabled, interworking none
PW backup disable delay 0 sec
Sequencing not set
MPLS Local Remote
------------ ------------------------------ -----------------------------
Label 30005 16003
Group ID 0x5000300 0x5000400
Interface GigabitEthernet0/4/0/1 GigabitEthernet0/4/0/2
MTU 1500 1500
Control word enabled enabled
PW type Ethernet Ethernet
VCCV CV type 0x2 0x2
(LSP ping verification) (LSP ping verification)
VCCV CC type 0x3 0x3
(control word) (control word)
(router alert label) (router alert label)
------------ ------------------------------ -----------------------------
Create time: 20/11/2007 21:45:07 (00:49:18 ago)
Last time status changed: 20/11/2007 21:45:11 (00:49:14 ago)
Statistics:
packet totals: received 0, sent 0
byte totals: received 0, sent 0
Backup PW:
PW: neighbor 2.2.2.2, PW ID 2, state is up ( established )
Backup for neighbor 1.1.1.1 PW ID 1 ( standby )
PW class not set, XC ID 0x0
Encapsulation MPLS, protocol LDP
PW type Ethernet, control word enabled, interworking none
PW backup disable delay 0 sec
Sequencing not set
MPLS Local Remote
------------ ------------------------------ -----------------------------
Label 30006 16003
Group ID unassigned 0x5000400
Interface unknown GigabitEthernet0/4/0/2
MTU 1500 1500
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
134 OL-28460-01
Virtual Private Network Commands
show l2vpn xconnect