8
——
General Precautions
Observe these precautions to ensure proper use of the device. Make sure to
read these precautions.
CAUTION
Do not touch the area around the thermal head during or right after the printing
process. This area will be hot and may cause burns.
Do not drop or insert small objects such as clips or pins into the printer. Doing so
may result in failure.
Exercise caution when carrying or transporting the device. Dropping the device
may damage other objects or cause injury.
Make sure to open the printer cover fully when it needs to be opened. Failure to
do so may result in the printer closing unexpectedly, which may cause injury.
Exercise caution when the printer cover is open. Contact with edges may result
in injury.
Do not open the printer cover while the printer is printing.
Do not print while the top ribbon cover is open. A failure may occur if the ribbon is
touched or a foreign object is dropped on it.
Do not use thinner, trichlene, benzene, ketone-based solvents, or cleaning cloths
with chemicals to clean the case surface.
Do not use the device in environments exposed to signicant levels of oil, metal
shavings, waste, and dust.
Do not spill liquids onto the device or expose the device to spray chemicals.
Do not step on, drop, hit, or otherwise subject the device to signicant force or
impact.
Make sure to use the control panel correctly. Pressing buttons randomly may
cause malfunction and even failure. Do not use sharp objects including tips of
pens to operate the control panel.
If some abnormality occurs during use, immediately stop using the device and
disconnect the power plug from the electrical outlet.
Do not disassemble the device for repairs in case of failure. Always contact the
dealer for repairs.
The auto cutter has internal blades near the media discharge port. Never insert
hands inside the media discharge port whether the printer is operating or not.
There is a risk of the thermal head being damaged by static electricity. Take mea-
sures to prevent the charging of static electricity in advance, and do not directly
touch the thermal head heating element and connector terminal parts when
handling the printer.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
