EasyManuals Logo

Citizen CL-E331 User Manual

Citizen CL-E331
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
Installation Precautions
CAUTION
Do not use or store the device in environments exposed to excessive heat,
moisture, direct sunlight, near heaters, extremely high or low altitudes, excessive
humidity, or excessive dust.
Do not use the device in environments, such as laboratories, where chemical
reactions occur.
Do not use the device in environments exposed to air that contains salt or toxic
gases.
Place printers on level, stable surfaces in environments with good ventilation. (Do
not place the printer such that the vents are against walls.)
Do not place objects on top of the device.
Using the device near radios or televisions or plugging the power cord into the
same electrical outlet as used by such devices may cause reception interfer-
ence.
Use the device in environments at specied power supply voltage and frequency.
Use only the included power cord. Do not use the included power cord with other
devices.
Do not place objects or step on power cords.
Do not pull or attempt to carry the device by the power cord or an interface cable.
Do not connect too many power cords to a single electrical outlet.
Do not bundle the power cord.
Hold the power cord by the power plug to connect and disconnect to/from electri-
cal outlets.
Ensure connectors are properly connected. In particular, reversing the polarity
may damage internal parts.
Turn the power switch off before connecting or disconnecting interface cables.
Do not run long signal lines or make connections with noisy devices to the extent
possible. If necessary, use shielded twisted pair cables for signal lines and take
any other necessary steps to ensure signal integrity.
Place the device near an electrical outlet and ensure that the power plug can be
unplugged easily so that the power to the device can be cut quickly if necessary.
Use electrical outlets with ground terminal screws. Using electrical outlets without
ground terminals may result in injury due to static electricity.
Do not install the printer in a location where there is vibration or in an unstable
location.

Table of Contents

Other manuals for Citizen CL-E331

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Citizen CL-E331 and is the answer not in the manual?

Citizen CL-E331 Specifications

General IconGeneral
Product colorBlack
Print technologyThermal transfer
Printing media thickness63.5 - 190 µm
Sustainability complianceYes
Sustainability certificatesCE, Federal Communications Commission (FCC), TUV, UL ECOLOGO, VCCI
Display-
Control typeButtons
ColorNo
Maximum resolution- DPI
Printable dot numbers300 dot
Ribbon width60 mm
Core diameter25 mm
Ribbon length300 m
Media thickness0.150 mm
Maximum label width118 mm
Maximum media length1625.6 mm
Maximum roll diameter125 mm
RS-232 ports1
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Flash memory16 MB
Internal memory32 MB
Built-in barcodesCODABAR (NW-7), Code 128 (A/B/C), Code 39, Code 93, EAN13, EAN8, GS1 DataBar, ITF, PDF417, QR Code, UPC-A, UPC-E
Server operating systems supportedWindows Server 2012, Windows Server 2016, Windows Server 2019, Windows Server 2022
Windows operating systems supportedWindows 10, Windows 11, Windows 7
Weight and Dimensions IconWeight and Dimensions
Depth266 mm
Width178 mm
Height173 mm
Weight2600 g
Label width104 mm

Related product manuals