Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
- 116 -
CT-S280
(1) Printer status (When n = 1 is specified)
3
5
Not waiting online recovery
6
FEED switch is not pressed
(2) Status caused by an offline condition (When n = 2 is specified)
2
3
Not in paper feed state triggered by FEED
switch
00H 0
In paper feed state triggered by FEED switch
5
Printing is not stopped because of “paper out”
state
00H 0
Printing is stopped because of “paper out” state
6
Bit 5: Printing is stopped if the Paper-end detector detects a “paper out”
state, or if the printer is out of paper when the Paper Near-end Sensor
is enabled by ESC c 4. At this time, bit 5= 1.
(3) Status caused by an error (when n = 3 is specified)
5
Unrecoverable error not occurred
Unrecoverable error occurred
6
Auto recovery error not occurred
Auto recovery error occurred
Bit 6: If a head overheat error is detected, the printing is stopped until the
head temperature falls. At this time, bit 6 = 1.
(4) Continuous paper detector status (When n = 4 is specified)
2
Paper found by Paper Near-end Sensor
Paper not found by Paper Near-end Sensor
3
Paper found by Paper Near-end Sensor
Paper not found by Paper Near-end Sensor
5
Paper found by Paper-end Sensor
Paper not found by Paper-end Sensor
6
Paper found by Paper-end Sensor
Paper not found by Paper-end Sensor
* If the command is executed right after power on in error status, correct
status may not be sent out.
To Next Page
Loading...
