Citizen CT-D150

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 394 -
GS I n
[Function] Sending the printer ID
[Code] <1D>H<49>H<n>
[Range] CT-S280/ CT-S601(II)/CT-S651(II)/CT-P29x series/ CT-S310II/ CT-S251/
CT-D150/CT-E351/CT-D151/CT-E651
1≤n≤3, 49≤n≤51, 65≤n≤67, n=69, 112
CT-S281/CT-S300/CT-S310/ CT-S2000/CT-S4000/CT-S801(II)/CT-S851(II)
1≤n≤4, 49≤n≤52, 65≤n≤67, n=69, 112
CT-S281
• Only Bluetooth model
90≦n≦92、n＝94、99
CT-S801II/CT-S851II/CT-S601II/CT-S651II/CT-S251/CT-D151/CT-E651
• Only Bluetooth I/F
90≦n≦92、n＝94、99、101≦n≦106
[Outline] [The specification which is common to the model]
• Sends the specified printer ID.
[Caution] [The specification which is common to the model]
• Under DTR/DSR control, the printer sends the printer ID after verifying that the host is ready to
receive.
• If the host is not ready to receive, the printer waits for the host to become ready to receive.
• Under XON/XOFF control, the printer sends the printer ID without checking whether or not the host is ready
to receive.
• Because this command is executed when data is mapped in the receive buffer, there may be a delay
between command receiving and printer ID sending depending on the condition of the receive buffer.
• If ASB (Automatic Status Back) is enabled by GS a, the host must discriminate between the printer ID due to
this command and the status due to ASB.
[The specification which depend on the model]
CT-S281/CT-S300/CT-S310/CT-S2000/CT-S4000/CT-S801(II)/CT-S851(II)
• Sending the Black mark length is valid only when Black mark paper is selected.