Citizen CT-D150

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 360 -
fn=101: Function 101 Changing Bluetooth setting
GS ( E pL pH fn m
[Code] <1D>H<28>H<45>H<pL><pH><fn><a><d1>...<dk>
[Range] 2≤(pL+pH×256) ≤66
fn=101
1≤a≤6, 8 (CT-S281BD: 1≤a≤8)
20H≤d≤2BH, 2DH≤d≤7EH, d1
≠20H, 22H
0≤k≤16 (a=1)
1≤k≤31 (a=2)
1≦k≦31(a=3)
1≦k≦31(a=4)
1≦k≦63(a=5)
k=10 (a=6)
1≦k≦31(a=7)
0≦k≦64(a=8)
[Outline] [The specification which depend on the model]
CT-S281BD, CT-S801II/CT-S851II, CT-S601II/CT-S651II/CT-S251/CT-D151/ CT-E651
• Changes the setting specified by “a” value.
a
Function
1
Changes the PIN code
2
Changes the Bluetooth device name or (iAP) accessory name
Changes the Bluetooth device name (CT-S281BD)
3
Changes (iAP) Manufacturer name
4
Changes (iAP) Model name
5
Changes (iAP) Protocol name
6
Changes (iAP) Bundle seed ID
7
Changes (iAP) Accessary name
8
Changes (iAP) Application ID
* Comma(2CH) cannot be used for value “d”.
* Space(20H) or double quotation mark(22H) cannot be used for the top character for value “d”
[Caution] [The specification which is common to the model]
• This function operates only in printer function setting mode.
• The value changed by this command is enabled by execution of function 2 (fn = 2: End of printer function
setting mode)
[The specification which depend on the model]
• Clearing PIN code (k=0) can be done only with following settings.
CT-S281BD
• MSW13-1 “BT Security1” - “Low”
CT-S801II/CT-S851II,, CT-S601II/CT-S651II, CT-S251, CT-D151/ CT-E651
• MSW13-1 “Security/Target” - “Low/All”