Citizen CT-D150

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 414 -
GS R 2 n t1 t2
[Function] Controlling bezel LED
[Code] <1D>H<52>H<32>H<n>H<t1>H<t2>
[Range] 0≤n≤2, 48≤n≤50
0, 2≤t1≤255, 0, 2≤t2≤255
[Outline] This command controls Bezel LED.
“n” specifies the mode of Bezel LED.
n
Bezel LED mode
0,48
OFF
1,49
ON
2,50 Blinking
3,51
Blinking during data receiption
t1: ON time of Bezel LED control
2≤t1≤255: ON time = t1 x 100ms
t1 = 0: ON time = Default (5 x 100ms)
t2: OFF time of Bezel LED control
2≤t2≤255: OFF time = t2 × 100ms
t2 = 0: OFF time = Default (5 x 100ms)
If “n” is set for OFF or ON, OFF/ON time is t1+ t2.
If “n” is set for Blinking, LED blinks twice with specified ON/OFF time.
[Caution] • This command supports only CT-S251.
• MSW11-1: Even if bezel LED is set up, change by a command is possible.
[Default] t1 = 2(200ms)
t2 = 2(200ms)
[Sample Program]
LPRINT CHR$(&H1D); CHR$(&H52); CHR$(&H32); CHR$(2); CHR$(10); CHR$(10);
･･･ On time of LED blinking is set for 1 sec and Off time of LED blinking is set for 1 sec.