Citizen CT-D150 - ESC { N

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 84 -
ESC { n
[Function] Specifying/canceling the inverted characters
[Code] <1B>H<7B>H<n>
[Range] 0≤n≤255
[Outline] [The specification which is common to the model]
• “n” is valid only for the lowest bit (n0).
• Rotate data in the line by 180 degrees and print it.
• Control by the lowest bit (n0) is shown as follows:
n0
Function
0
Canceling inverted characters.
1
Specifying inverted characters.
[Caution] [The specification which is common to the model]
• This command is valid only when it is specified at the beginning of a line.
• This command does not affect the PAGE MODE.
[Default] n=0
[Sample Program]
LPRINT CHR$(&H1B) ;"{"; CHR$(0);
LPRINT "TEN"; CHR$(&HA);
LPRINT "ELEVEN"; CHR$(&HA);
LPRINT CHR$(&H1B) ;"{"; CHR$(1);
LPRINT "TEN"; CHR$(&HA);
LPRINT "ELEVEN"; CHR$(&HA);
[Print Results]
Inversion canceled
Inversion specified
Paper feed direction