Citizen CT-D150 - Page 142

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 141 -
[The specification which depend on the model]
CT-S280/CT-S281/CT-P29x series
• Bit 2 of the 1st byte (printer information) of the status sent in 4 bytes is set to 00H because
drawer is not supported.
CT-S281
• Bit 0, 1 of the 3rd byte (Paper Sensor information) is set to 00H, if the Paper-end detector is uninstalled, or if
MSW2-8= 0.
• Bit 2, 3 of the 3
rd
byte (Paper Sensor information): When cover is open, paper end may be detected as well.
CT-P29x series/CT-S310 II/CT-D150/CT-E351
• Bit 0, 1 of the 3
rd
byte (Paper Sensor information): Bit is fixed at 0 due to no paper near end function.
(1) 1st byte (Printer information)
Bit
Status
Hex.
Decimal
0
Unused
00H
0
1
Unused
00H
0
2
Status of pin 3 of drawer kick-out connector = “L”
00H
0
Status of pin 3 of drawer kick-out connector = “H”
04H
4
3
Online status
00H
0
Offline status
08H
8
4
Unused
10H
16
5
Cover closed
00H
0
Cover open
20H
32
6
Not in paper feed state triggered by FEED switch
00H
0
In paper feed state triggered by FEED switch
40H
64
7
Unused
00H
0