Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
- 236 -
CT-E651
• Setting MSW 1 (a=1)
1
Does not report power on.
2
Sets input buffer capacity to 4K bytes.
Sets input buffer capacity to 45 bytes.
3
Sets input buffer full and offline to be Busy.
Sets to be busy with input buffer full.
4
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.
At the occurrence of receiving error, ignores the data.
5
7
Does not reset at serial I/F pin 6.
Resets at serial I/F pin 6.
8
Does not reset at serial I/F pin 9.
Resets sat serial I/F pin 9.
* With MSW1-2, With serial I/F, 45 bytes are enabled only when DMA control
(MSW7-6) is disabled.
• Setting MSW 2 (a=2)
2
3
Disables stored printing.
4
Immediately after digit reaches full, line-feed is taken.
Immediately after digit reaches full, data wait is taken.
5
After cover close and PE recovery, prints as it is.
49
After cover close and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
8
• Setting MSW 3 (a=3)
1
After clearing cutter error, can be restored by Feed SW.
After clearing cutter error, cannot be restored by Feed SW.
2
PE is outputted at the time of PNE detection.
PE is not outputted at the time of PNE detection.
Sets EPSON compatible mode.
Sets CBM1000-compatible mode.
8
48 (Default)
Sets cover open error during printing to be auto recovery
error.
49
Sets cover open error during printing to be recoverable
error.
• Setting MSW 4 (a=4)
3
Feed & Cut at TOF disabled.
Feed & Cut at TOF enabled.
8
Cut method is determined according to the cut command.
49 (Default)
Partial cut is performed regardless of cut command. (full
but by command: enabled).
To Next Page
Loading...
