Citizen CT-D150 - Page 73

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 72 -
[Caution] • With double height and double width being specified simultaneously, quadruple characters are
created.
• An underline is attached to the full character width, which, however, is not attached to the part having been
skipped by the horizontal tab (HT). Neither is it attached to 90°-right-turned characters.
• The underline width is as specified by the ESC – command. (The default setting is 1 dot width.)
• Setting by this command is invalid for Kanji except setting and canceling of enhanced printing.
• In case characters with different vertical magnification ratios coexist on the same line, they are printed on the
same base line.
• ESC E, ESC M, ESC –, and GS ! can individually set or cancel the mode but the command processed last is
valid.
• Setting or canceling of enhanced 3rd bit is valid for alphanumeric and kana and kanji. Other print mode is
valid only for alphanumeric and kana characters.
• Setting memory SW 3-7 to ON allows the horizontal and vertical relations to be interchanged when
90°-right-turnning of character is specified.
[Default]
n=0
[See Also] ESC E, ESC -, GS !
[Sample Program]
[Print Results]
LPRINT CHR$(&H1B);"!"; CHR$(&H00);"H";
LPRINT CHR$(&H1B);"!"; CHR$(&H01);"H";
LPRINT CHR$(&H1B);"!"; CHR$(&H08);"H";
LPRINT CHR$(&H1B);"!"; CHR$(&H10);"H";
LPRINT CHR$(&H1B);"!"; CHR$(&H20);"H";
LPRINT CHR$(&H1B);"!"; CHR$(&H80);"H";
LPRINT CHR$(&H1B);"!"; CHR$(&HB9);"H";
LPRINT CHR$(&HA);
Font A
Font B
Font A + Emphasis
Font B + Emphasis
+ Quadruple + Underline
Font A + Underline
Font A + Double width
Font A + Double height