91
Reading the statistics
ðAt any point of time, the user can press and hold the <TOGGLE> key for 2 seconds to
go through the statistics.
st
ðThe screen will display the 1 parameter as number of readings 'n' along with the star
symbol which indicates that the user is in the statistics result mode.
ðThe user can now go through the other parameters such as average, Min value, M a x
value, Standard deviation, Difference, Co efficient of Variance by pressing the
<TOGGLE> key.
ðThe user can come out of the statistics mode by pressing the < CANCEL > key.
Deleting statistics:
ðThe user can delete the statistics by pressing the <TARE> key for 2 seconds when in
'StAt' mode.
ðThis will delete the previous data entries and start again.
ðThe entire data is will be sent to the terminal or to the printer before it gets deleted.
Note:
ðThe minimum weight on the pan should be 10d (where'd' is the accuracy of the
scale), if less than that, then the weight will not be taken into consideration for
calculating statistics.
ðThe statistics will be deleted if the system goes into standby mode (i.e. if the auto-off
feature is active or by power on-off).
ðThe user can also print the statistics by pressing the <PRINT> key when in 'StAt' mode.
-----------------------------------
28-Jul-10 03:19PM
Citizen
Model CX 220
Ser.no. 9223102
Ver.no. r0.1.5.3
ID 1234567
-----------------------------------
1 + 1.5750 g
2 + 2.3500 g
3 + 7.8950 g
4 + 4.1750 g
-----------------------------------
n 4
max 7.8950 g
min 1.5750 g
avg 3.9987
std 2.8169
var 7.9349
-----------------------------------
28-Jul-10 03:23PM
Name:
................
-----------------------------------
-----------------------------------
1 + 1.5750 g
2 + 2.3500 g
3 + 7.8950 g
4 + 4.1750 g
-----------------------------------
n 4
max 7.8950 g
min 1.5750 g
avg 3.9987
std 2.8169
var 7.9349
-----------------------------------
WITH GLP ON WITH GLP OFF
92
If the balance is connected externally to PC or Printer through RS 232 C then, whenever user enter into the menu of Statistics & presses in the
print key , the user can obtain the list of parameters shown in the below example :
To Next Page
Loading...
Need help?
General
