The “Percent weighing” function enables you to weigh in to a preset value (1, 10,
20,50, 100%, Free, 100r, 100L, AtroM, AtroD) and to determine deviations from this
target value.
Percent Weighing (%) presupposes that you have preselected the “F per” function in
the menu
Procedure
ðPlace the empty container on the pan.
ðPress the <TARE> key to tare the balance.
ðPress the <TOGGLE> key briefly until “PER (%)” appears on the display.
Your balance now needs the weight of a reference percent (%).
ðPress and hold the <TOGGLE> key until you are prompted to load the reference
PER (%).
ðYour balance suggests the last set reference % as the reference percent (%)
You can accept this suggestion or select one of the other reference percent (%)
available (1,10, 20, 50, 100 %, Free, 100r, 100L, AtroM, AtroD) by briefly pressing the
<TOGGLE> key.
ðDefault is 1%
The FREE option allows the user to set any reference other than the standard available
reference.(Default value is 01.00 % and maximum possible value is 99.99%)
ðNow place reference sample on the pan.
ðThen press <TARE> key. Until dashes are displayed, your balance is
calculating the reference
ðAfter your balance has determined the reference weight, it is ready for Percent
Weighing.
You can use the <TOGGLE> key at any time to switch the display between the Percent
(%) display, weighing unit 1 and weighing unit 2.
Note : The current set weight remains stored until it has been redetermined.
6.2.1 FREE (Reference settings)
The FREE option allows the user to set any reference other than the standard available
reference.
(Default value is 1.00% and maximum possible value is 99.99%)
Procedure
ðPlace the empty container on the pan.
ðPress the <TARE> key briefly to tare the balance.
ðPress the <TOGGLE> key briefly until “PER” appears on the display.
Your balance now needs the weight of a reference number.
ðPress and hold the <TOGGLE> key until you are prompted to load the reference
pieces.
ðYour balance suggests the last set reference no. as the reference number.
ðPress the <TOGGLE> key unit FREE is displayed.
ðPress the <TARE> key to enter FREE reference settings.
ðLast stored FREE value is displayed. Flashing digit indicates that digit value or
place can be changed.
ðPress <TOGGLE> key ( ) to change the value of the Flashing digit.
ðPress <CAL> key ( )to shift the flashing digit from Left to Right
ðWhen you have placed exactly the same number of pieces on the weighing pan
as set in the FREE setting, press TARE key.
As soon as the weighing result is stable, the calculated average piece weight is accepted
as the reference
50
49
6.2 Percent Weighing (%)
To Next Page
Loading...
Need help?
General
