69
This feature is used to check whether a sample corresponds to a preset target or is with a
specific tolerance range.
The results displayed can also be available on external port, which with the help of
electronic processing can be used to control additional devices.
The check weighing procedure will always be carried out in unit 'gm'.
Check weighing presupposes that you have selected the 'F CHw' in the user menu.
Procedure
ðPress the <TARE> key briefly to tare the balance.
ðPress the <TOGGLE> key briefly until “CW” is displayed on the display.
Your balance now needs the target and tolerance values.
If entering the check weighing for the first time the target and tolerance setting menu will
be displayed.
Target and Tolerance Settings
ðPress and hold the <TOGGLE> until the target and tolerance setting menu is
prompted.
ðPress the <TOGGLE> key to browse through the TARGET, HI, and LOW setting.
ðPress the <TARE> key to enter specific setting.
ðPress the <TOGGLE> key ( ) to change the value of the flashing digit.
ðPress the <CAL> key ( ) to change the flashing digit from left to right.
ðAfter proper setting of values press the <TARE> key.
ðPress and hold the <TARE> key to store the values of target and tolerance values.
Note: To view the weight when the balance displays LL or HH press the <CAL> key press
the <CAL> key again to display LL or HH.
70
6.6 Check Weighing
To Next Page
Loading...
Need help?
General
