© 1999-2017 Citrix Systems, Inc. All rights reserved. p.18https://docs.citrix.com
Setting Up the Model MPX Appliance
Jul 15, 2013
The following procedure describes how to set up the NetScaler Gateway Model MPX appliance for the first time.
To physically connect the NetScaler Gateway appliance
1. Install NetScaler Gateway in a rack if it is rack-mounted.
2. Connect the power cord to the AC power receptacle.
3. Connect either the serial cable to a Windows-based computer, a cross-over cable to a Windows-based computer, or an
RJ-45 network cable to a network switch and NetScaler Gateway.
4. Configure the TCP/IP settings by following the instructions in Configuring Initial Settings by Using the Serial Console.
To Next Page
Loading...