© 1999-2017 Citrix Systems, Inc. All rights reserved. p.3https://docs.citrix.com
About the NetScaler Gateway MPX Appliance
May 11, 2015
The hardware platform (appliance) used for NetScaler Gateway is the MPX that runs on the NetScaler platform. This
appliance supports classic and nCore NetScaler Gateway software deployments. The MPX appliance supports NetScaler
Gateway 10.1 and later, Access Gateway 10, Access Gateway 9.3, Enterprise Edition, and Access Gateway 9.2, Enterprise
Edition.
Note: NetScaler Gateway 10.5. NetScaler Gateway 10.1, and Access Gateway 10 must run on an nCore version of the
appliance.
The following table shows the versions of the NetScaler Gateway and Access Gateway software that are supported on
the MPX appliance.
NetScaler Gateway version MPX support
9.2 Classic Yes
9.2 nCore
You must install a minimum of Build 55.5 to use nCore on a 9.2 appliance.
Yes
9.3 nCore Yes
10 nCore Yes
10.1 nCore and newer Yes
The preconfigured IP address of NetScaler Gateway is 192.168.100.1 and the subnet mask is 255.255.0.0. To change the IP
address, you can use a serial cable and a terminal emulation program, or you can connect NetScaler Gateway by using
network cables and the configuration utility.
You can install the NetScaler Gateway appliances in the DMZ or the secure network. For more information about
deployment scenarios, see Deploying NetScaler Gateway.
For information about setting up the MPX appliance in a rack, see Installing the Model MPX Appliance in a Rack. This
section discusses the MPX specifications and how to install and configure the MPX appliance.
To Next Page
Loading...
Need help?
General