© 1999-2017 Citrix Systems, Inc. All rights reserved. p.64https://docs.citrix.com
Turning on the Model 2010 Appliance
Jan 25, 2011
After you install the Access Gateway appliance in a rack and connect the cables, you are ready to turn on the appliance.
1. Verify that you are connected to the appliance through a console or Ethernet port.
This step will ensure that you can configure the appliance after you turn it on.
2. Plug in the power cable.
Note: The model 2010 appliance does not have a power switch, so the appliance turns on when you plug it in.
As it turns on, the appliance hums, and various lights on the surface flash. After a few seconds, the rapid changes in sound
and lights become a steady hum.
To Next Page
Loading...