© 1999-2017 Citrix Systems, Inc. All rights reserved. p.65https://docs.citrix.com
Configuring the Model 2010 Appliance
Nov 12, 2012
You can use a serial console to configure the initial settings of Access Gateway. You can use the serial console to set the IP
address and subnet of the network adapter that is called Interface 0, as well as the IP address of the default gateway
device. You configure subsequent settings using the Management Console in Access Gateway 5.0 or the Administration
Tool in Access Gateway 4.6.
For more information about configuring Access Gateway to work in your network, see the following:
If you are using Access Gateway 5.0, see Access Gateway 5.0.
If you are using Access Gateway 4.6, download the Access Gateway 4.6, Standard Edition PDF.
To Next Page
Loading...