Citrix NetScaler SDX 8015 User Manual

© 1999-2017 Citrix Systems, Inc. All rights reserved. p.116https://docs.citrix.com
Log on to NetScaler instance and use the NetScaler command line interface to complete the remaining configuration
steps.
The following table list the tasks, NetScaler commands, and examples for creating the required configuration on the
NetScaler instances.
Task Syntax Example
Create VLANs and set the MTU of the desired
VLANs for supporting jumbo frames.
add vlan <id> -mtu
<positive_integer>
show vlan <id>
add vlan 10 -mtu 9000
add vlan 20 -mtu 9000
add vlan 30 -mtu 1500
add vlan 40 -mtu 1500
Bind interfaces to VLANs. bind vlan <id> -ifnum
<interface_name>
show vlan <id>
bind vlan 10 -ifnum 10/1 -
tagged
bind vlan 20 -ifnum 10/2 -
tagged
bind vlan 30 -ifnum 10/1 -
tagged
bind vlan 40 -ifnum 10/2 -
tagged
Add a SNIP address. add ns ip <IPAddress>
<netmask> -type SNIP
show ns ip
add ns ip 198.51.100.18
255.255.255.0 -type SNIP
add ns ip 198.51.101.18
255.255.255.0 -type SNIP
Create services representing HT TP servers. add service <serviceName>
<ip> HTTP <port>
show service <name>
add service SVC-S1
198.51.100.19 http 80
add service SVC-S2
198.51.100.20 http 80
add service SVC-S3
198.51.101.19 http 80
add service SVC-S4
198.51.101.20 http 80
Create HTTP load balancing virtual servers and bind add lb vserver <name> HTTP add lb vserver LBVS-1 http

Citrix NetScaler SDX 8015 Specifications

General

Brand	Citrix
Model	NetScaler SDX 8015
Category	Server
Language	English