© 1999-2017 Citrix Systems, Inc. All rights reserved. p.266https://docs.citrix.com
Bandwidth thresholds are not set.
23) Interface LO/1 (Netscaler Loopback interface) #22
flags=0x20008020 <ENABLED, UP, UP>
MTU=1500, native vlan=1, MAC=0c:c4:7a:41:ea:94, uptime 44h00m15s
LLDP Mode: NONE
RX: Pkts(103847611) Bytes(14441166499) Errs(0) Drops(0) Stalls(0)
TX: Pkts(206723664) Bytes(20488047637) Errs(0) Drops(0) Stalls(0)
Bandwidth thresholds are not set.
Done
>
4. In the show interface command's output, verify that all of the interfaces are enabled and the status of every
interface is shown as UP/UP.
Notes:
· T he interface status is displayed as UP/UP only if the cables are connected to the interfaces.
· If you do not have an SFP+ transceiver for every port, verify the interfaces in stages. After checking the first set
of interfaces, unplug the SFP+ transceivers and plug them in to the next set of ports.
5. Run the following command for each of the interfaces that are not in the UP/UP state:
* enable interface 10/x
* enable interface 40/x
where x is the new interface number.
Example
> enable interface 10/1
Done
> enable interface 40/1
Done
>
To Next Page
Loading...
