117
ENGINE
AUXILIARY EQUIPMENT DRIVE BELT
Engines : 8HX - 8HWWith compressor and alternator
B1BP2MKC
B1BP2MJD
Tools
[1] Pliers for removing plastic pegs : 7504-T.
[2] Tensioner roller compression lever : (-).0194.E.
[3] Tensioner roller setting peg Ø4 mm : (-).0194.F.
Removing.
Disconnect the battery negative cable.
Raise and support the vehicle, wheels hanging.
Remove the front RH wheel.
Move aside the splash-shield, using tool [1].
IMPERATIVE : In the case of belt re-use, mark the direction
of rotation of the belt. If the index on the tensioner roller
is outside the marks, change the auxiliary equipment
drive belt.
Remove :
The alternator (1).
The aircon compressor (2).
Detension the auxiliary belt tensioner roller, using tool [2].
Position the peg [3]. Remove the auxiliary drive belt.
C3
To Next Page
Loading...
