162
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engines : 8HY - 8HV
B1EP18XC
Adjusting the timing belt tension (continued).
IMPERATIVE : Never rotate the engine backwards.
WARNING : Do not touch or damage the track of the target of the engine speed sensor (14).
Peg the crankshaft, using tool [3].
Check the position of the tensioner roller (the alignment of the marks «f» and «g» should be correct).
If this is not the case, repeat the operation to tension the belt.
Peg the camshaft pulley, using tool [2].
IMPERATIVE : Should it be impossible to peg the camshaft, check that the offset between the
camshaft hole and the pegging hole is not more than 1 mm. If the offset is too great, repeat the
operation.
Remove the pegs [2] and [3].
Refit tool [1] at «a».
Remove the screw (8).
Complete the refitting.
C3
To Next Page
Loading...
