ENGINE
179
CHECKING AND SETTING THE VALVE TIMING
Engines : 6FZ - RFN 2003 #
Setting the timing (continued)
Turn the tensioner roller (8), using tool [5a] to go beyond slot (b).
Position the tool [5b] to lock the index (a) and remove the tool [5a].
Reposition the timing belt (7) on the crankshaft pulley.
Hold the timing belt (7) in place using tool [3].
Fit the timing belt (7) in place, respecting the following order :
- Guide roller (10).
- Inlet camshaft pulley (6).
- Exhaust camshaft pulley (5).
- Coolant pump (11).
-Tensioner roller (8).
NOTE : Make so that the belt (7) is as flush as possible with the exterior face of the various
pinions and rollers.
Remove :
Tool [3].
Tool [1] from the exhaust camshaft pulley.
Tool [5b] from the tensioner roller (8).
Refit :
The lower timing cover (4) (by moving the engine)
The crankshaft pulley (2).
Screw (3) of the crankshaft pulley
Tighten screw (3) to 4 ± 0,4 m.daN, then angular tighten to 53° ± 4°, tool [4].
B1EP1BCD B1EP1BDC
XSARA - XSARA PICASSO
To Next Page
Loading...
