248
INJECTION
XSARA CHECKING AND SETTING THE DELPHI MECHANICAL INJECTION PUMP
Tools.
[1] Flywheel locating peg 7014-T.J.
[2] H M8 screw (-).0188.E. Tool kit C.0188
[3] Injection pump setting peg Ø 6 mm (-).0188.H
After carrying out the necessary dismantling operations on the vehicle, proceed in the following manner :
Remove :
- The screws (6), (7), (9), (10) and (12).
- The upper casing (8).
- The intermediate casing (11).
WARNING : Refit the screw (6) equipped with a washer. (Thickness 5 mm).
- Turn the front RH wheel to turn the engine. (Normal direction of rotation).
- Bring the camshaft and injection pump pulleys to their setting point.
- Position the flywheel peg, using tool [1]. (From below the vehicle).
- Turn the engine until the peg [1] engages in the flywheel.
B1BP1S9CB1EP12NC
Engine : WJY (continued)
To Next Page
Loading...
