260
INJECTION
CHECKS : TURBO PRESSURE
Engine : RHY
TOOLS.
[1] Pressure gauge for checking boost pressure : 4073-T.A Tool kit 4073-T
[2] Sleeve for checking boost pressure : 4185-T
Checks.
IMPERATIVE : respect the following checking requirements : Engine at running tempe-
rature. Vehicle running at full load.
Preparation.
- Remove the collar (3) and the sleeve.
- Insert the tool [2] between the pipe (1) and the duct (2).
- Position tool [1] in the vehicle.
- Connect the pressure gauge [1] to the tool [2] with its tube « a » long enough for the gauge
to be positioned inside the vehicle.
Procedure.
- Start the engine.
- Engage first gear and start the engine.
- Engage the gears up to third gear.
- Decelerate to 2000 rpm.
- Gradually accelerate.
- Check the pressure : 0.95 ± 0.05 Bar.
- Remove the tools, refit the collars (3) and the sleeve.
B1BP1ZXD
XSARA PICASSO
To Next Page
Loading...
