308
CLUTCH
GEARBOX
DRIVESHAFTS
RECOMMENDATIONS - PRECAUTIONS (AUTOMATIC GEARBOX - AL 4 )
Engines : KFV - NFU - RFN - RHZ
AL4 gearbox only
AL4
B2CP31FD
PROCEDURE BEFORE REPAIRS
Oil level AL 4 (prior conditions).
- Vehicle in horizontal position.
- Check gearbox is not in back-up mode.
- Remove the oil filler plug (3).
- Add 0.5 litres extra oil into the gearbox.
- Foot on the brake, change through all the gears.
- Selection lever in position "P".
- Engine running, at idle.
- Oil temperature : 60°C (+8°C; -2°C), measured with the aid of a diagnostic tool.
- Remove the oil level plug (3).
- Thread of oil then "drip-drip": refit plug (3). Tighten 2.4 m.daN.
- "Drip-drip" or nothing : refit the plug (3).
- Stop the engine.
- Add 0.5 litres extra oil into the gearbox.
- Repeat the oil level procedure.
NOTE : The level is correct at the moment the thread of oil becomes drip-drip.
- Refit the oil filler plug (3). Tighten to 2.4 m.daN.
- Initialise the oil usage counter (open the diagnostic tool procedure).
NOTE : Dimension X : TU and EW engines = 81 mm DW engines = 77 mm.
C3 - XSARA - XSARA PICASSO
To Next Page
Loading...
