AXLES
SUSPENSION
STEERING
316
SAXO - All Types AXLE GEOMETRY
Geometry of the axles at reference height.
Rear heightFront height
Reminder : Measuring the rear height
H2 = Distance between the ground and the rear crossmember
Reminder : Measuring the front height
H1 = Distance between the ground and the mounting face of the fixings
The front heights H1 are measured between the ground and the moun-
ting face of the arm fixings (1) at the point «a».
The rear heights H2 are measured between the ground and the mounting
face of the rear crossmember (2) at «b» and «c».
A> B =Negative figure: – = TOE-OUT
A < B = Positive figure : + = TOE-IN
WARNING
B3BP07UC B3BP07VD
B3CP02UC
To Next Page
Loading...
