CITROEN C4 2004 - Page 114

111
ENGINES
SPECIAL FEATURES: TIGHTENING TORQUES
Cylinder block
Crankshaft bearing cap cover
Tightening method
Pre-tightening the 10 screws (17) (from 1 to 10) to 1
Pre-tightening the 14 screws (19) (from 11 to 24) to 0,6
Tightening the 2 screws (18) (inside the flywheel bell housing) to 180°
Slacken the screws (17) by 3
Tightening the 10 screws (17) (from 1 to 10) to 140°
Tightening the screws (17) (from 1 to 10) by 0,8
Tightening the 14 screws (19) (from 11 to 24) to 1
Engine: 9HX
B1DP1LLD
Sequence for tightening the screws (17), (18) and (19)
(17) Bearing cap fixing screws (screw M9)
(18) Crankshaft bearing cap cover screws (screw M6)
(19) Crankshaft bearing cap cover screws (screw M6)
UK-C4-page048-130-2004 15/11/04 9:23 Page 111