374
BRAKES
BLEEDING AND FILLING THE BRAKING SYSTEM
Bleeding the braking circuit with the bleed apparatus.
Connect the bleed apparatus [1] on the brake fluid reservoir (4).
Adjust the apparatus pressure to 2 Bars.
For each brake circuit:
- Couple a transparent tube on the bleed screw.
- Submerge the other end of the tube in a clean container.
- Open the bleed screw.
- Wait until the brake fluid flows out without air bubbles.
- Close the bleed screw.
- Remove the bleed apparatus [1].
Check the level of the brake fluid (between the «DANGER» level and the «MAXI» level).
Fill if necessary with the the approved and recommended synthetic brake fluid.
To Next Page
Loading...
