308
CLUTCH
GEARBOX
DRIVESHAFTS
RECOMMENDATIONS - PRECAUTIONS (AL4 AUTOMATIC GEARBOX)
Engines: NFU - RFJ
B2CP3X6D
B2CP3X5C
Draining - Filling.
Tooling recommended.
[1] Filling cylinder : (-).0341
Draining.
IMPERATIVE: The gearbox should be drained when the oil is warm (at least
60°C), to eliminate the impurities in suspension in the oil.
NOTE: Draining is partial, the converter cannot be completely emptied.
Remove:
- The level plug (2).
- The oil draining and overflow plug (1).
NOTE: Approx. 3 litres of oil should flow out.
Filling.
- Refit the drain plug (1), tighten to 0,9 ± 0,2 m.daN.
- Remove the oil filler cap (2).
- Use tool [1].
Oil capacity:
- Oil capacity for dry gearbox: 5,85 litres.
- Oil remaining after draining: 3 litres (approx.).
- Quantity of oil to be put back in: 3 litres (approx.).
- Refit the oil filler cap (2) (equipped with a new seal), tighten to 2,4 m.daN.
Initialise the oil wear counter (follow the diagnostic tool procedure).
To Next Page
Loading...
