CITROEN C4 2004 - Page 126

123
ENGINES
SPECIAL FEATURES: TIGHTENING TORQUES
Cylinder block
Crankshaft bearing cap cover
Tightening method
Pre-tightening the 10 screws (17) (from 1 to 10) to 1
Pre-tightening the 14 screws (19) (from 11 to 24) to 0,6
Tightening the 2 screws (18) (inside the flywheel bell housing) to 0,8
Slacken the screws (17) by 180°
Tightening the 10 screws (17) (from 1 to 10) to 3
Tightening the screws (17) (from 1 to 10) by 140°
Tightening the 14 screws (19) (from 11 to 24) to 0,8
Engines: 9HY - 9HZ
B1DP1LLD
(17) Bearing cap fixing screws (screw M9)
(18) Crankshaft bearing cap cover screws (screw M6)
(19) Crankshaft bearing cap cover screws (screw M6)
UK-C4-page048-130-2004 15/11/04 9:23 Page 123